Figure 111 Telnet Configuration On A Tcp/Ip Network; Table 80 Remote Management: Www; Telnet; Configuring Telnet - ZyXEL Communications P-660H Series User Manual

The following table describes the labels in this screen.

Table 80 Remote Management: WWW

LABEL
Port
Access Status
Secured Client IP A secured client is a "trusted" computer that is allowed to communicate with the
Apply
Cancel

15.3 Telnet

You can configure your ZyXEL Device for remote Telnet access as shown next. The
administrator uses Telnet from a computer on a remote network to access the ZyXEL Device.

Figure 111 Telnet Configuration on a TCP/IP Network

15.4 Configuring Telnet

Click Advanced > Remote MGMT > Telnet tab to display the screen as shown.
Chapter 15 Remote Management Configuration
DESCRIPTION
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Click Apply to save your settings back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
P-660H/HW-D Series User's Guide
204