Remote Node Configuration; Introduction To Remote Node Setup; Remote Node Profile Setup; Ethernet Encapsulation - ZyXEL Communications P-335WT User Manual
Firewall router with print server 802.11g wireless firewall router with print server
Hide thumbs
Also See for P-335WT:
- User manual (485 pages) ,
- Quick start manual (121 pages) ,
- User manual (493 pages)
Table of Contents
Advertisement
Remote Node Configuration
This chapter covers remote node configuration.
27.1 Introduction to Remote Node Setup
A remote node is required for placing calls to a remote gateway. A remote node represents
both the remote gateway and the network behind it across a WAN connection. Note that when
you use menu 4 to set up Internet access, you are actually configuring a remote node. The
following describes how to configure Menu 11.1 Remote Node Profile, Menu 11.3 - Remote
Node Network Layer Options, Menu 11.5 - Remote Node Filter and Menu 11.6 - Traffic
Redirect Setup.
27.2 Remote Node Profile Setup
From the main menu, select menu option 11 to open Menu 11 Remote Node Profile (shown
below).
The following explains how to configure the remote node profile menu.
27.2.1 Ethernet Encapsulation
There are two variations of menu 11 depending on whether you choose Ethernet
Encapsulation or PPPoE Encapsulation. You must choose the Ethernet option when the
WAN port is used as a regular Ethernet. The first menu 11.1 screen you see is for Ethernet
encapsulation shown next.
Chapter 27 Remote Node Configuration
C
H A P T E R
P-335 Series User's Guide
2 7
305
Advertisement
Chapters
Table of Contents
Troubleshooting
