Dell POWERCONNECT 6200 SERIES Configuration Manual page 86

Area 1 (0.0.0.1) - Stub
IR (5.3.0.0)
3000:1:2::/64 eui64
Figure 4-4. OSPF Configuration—Stub Area and NSSA Area
Configure Router A: Router A is a backbone router. It links to an ASBR (not defined here) that routes
traffic outside the AS.
• Globally enable IPv6 and IPv4 routing:
(console) #configure
ipv6 unicast-routing
ip routing
• Configure IP address and enable OSPF on VLAN routing interfaces 6 and 12 and enable IPv6 OSPF on
the interfaces. (OSPF is enabled on the IPv4 interface in the next code group.)
interface vlan 6
routing
ip address 10.2.3.3
ipv6 address 3000:2:3::/64 eui64
ip ospf area 0.0.0.0
ipv6 ospf
exit
interface vlan 12
routing
ip address
86
Routing Configuration
Router B - ABR (5.5.5.5)
VLAN 10
10.1.2.2/24
10.2.4.2
3000:2:4::/64
VLAN 17
IR (5.4.0.0)
Area 2 (0.0.0.2) - NSSA
255.255.255.0
10.3.100.3 255.255.255.0
Area 0 (0.0.0.0) - backbone
10.2.3.3/24
Router A - backbone
3000:2:3::/64
(3.3.3.3)
VLAN 6
VLAN 5
10.2.3.2
3000:2:3::/64
AS-1 AS-2
10.3.100.3/24
ASBR (5.1.0.0)
3000:3:100::/64
VLAN 12