Using The Web Interface To Configure Vlan Routing - Dell POWERCONNECT 6200 SERIES Configuration Manual

Example 3: Set Up VLAN Routing for the VLANs and Assign an IP Address
The following code sequence shows how to enable routing for the VLANs and how to configure the IP
addresses and subnet masks for the virtual router ports.:
console#configure
console(config)#interface vlan 10
console(config-if-vlan10)#routing
console(config-if-vlan10)#ip address 192.150.3.1 255.255.255.0
console(config-if-vlan10)#exit
console#configure
console(config)#interface vlan 20
console(config-if-vlan20)#routing
console(config-if-vlan20)#ip address 192.150.4.1 255.255.255.0
console(config-if-vlan20)#exit
Example 4: Enable Routing for the Switch:
In order for the VLAN to function as a routing interface, you must enable routing on the VLAN and on the
switch.
console(config)#ip routing

Using the Web Interface to Configure VLAN Routing

Use the following screens to perform the same configuration using the Web Interface:
• Switching > VLAN > VLAN Membership. To create the VLANs and specify port participation.
Switching > VLAN > Port Settings. To set the PVID and VLAN type.
•
• Routing > VLAN Routing > Configuration. To enable routing on Vlans.
• Routing > IP > Configuration. To enable routing for the switch.
• Routing > IP > Interface Configuration. To configure VLAN IP addresses and subnet masks.
76
Routing Configuration