Dell POWERCONNECT 6200 SERIES Configuration Manual page 84

IPv4 (OSPFv2)
• Enable routing for the switch:
console#config
ip routing
exit
Enable routing and assign IP for VLANs 70, 80 and 90.
config
interface vlan 70
routing
ip address 192.150.2.2 255.255.255.0
exit
interface vlan 80
routing
ip address 192.130.3.1 255.255.255.0
exit
interface vlan 90
routing
ip address 192.64.4.1 255.255.255.0
exit
exit
Specify a router ID. Disable 1583 compatibility to prevent a routing loop (IPv4-only).
config
router ospf
router-id 192.150.9.9
no 1583compatibility
exit
exit
OSPF is globally enabled by default. To make it operational on the router, you configure OSPF for particular
interfaces and identify which area the interface is associated with. The following commands also sets the
priority and cost for the ports:
84
Routing Configuration
IPv6 (OSPFv3)
console#config
ipv6 unicast-routing
exit
config
interface vlan 70
routing
ipv6 enable
exit
interface vlan 80
routing
ipv6 address 2002::1/64
exit
interface vlan 90
routing
ipv6 address 2003::1/64
exit
exit
config
ipv6 router ospf
router-id 1.1.1.1
exit
exit