Nsa Login And Access - ZyXEL Communications NSA 210 User Manual

Chapter 18 Troubleshooting
Connect the hard disk to your Windows computer (follow the instructions of your
1
hard disk manufacturer on how to do this). Go to My Computer > Manage >
Disk Management. Locate the hard disk (on some systems, the hard disk shows
up as the disk without a drive letter assigned to it).
Right-click on all partitions in the hard disk and click Format.
2
Make sure you select the correct hard disk. Otherwise, all data in
the formatted hard disk will be gone.
I don't want to initialize my hard disk but I cannot clear the Initialize Hard Disk
check box in the Firmware Path screen.
The checkbox in the Firmware Path screen can be cleared only if the hard disk
format is compatible with the NSA. If the hard disk format is not compatible with
the NSA, this checkbox is checked by default and cannot be modified.
I have at least two NSAs in my network, how do I identify which one I want to
configure in the NAS Starter Utility screens.
If you have several NSAs connected to your computer/network, you can do the
following to identify the NSA you want to configure:
Go to the Device List screen.
1
Hover your mouse over the host name under Host until a box pops up. This shows
2
the details of each NSA device.
You can identify the device you want to configure by checking the MAC addresses
3
of the NSAs. You can check the MAC address of your NSA by checking the attached
sticker in the device housing.

18.4 NSA Login and Access

I forgot the server name of the NSA.
• The default server name is nsa210.
390
NSA210 User's Guide