This chapter acquaints you with the front and rear panels, shows you how to make the connections,
3.1 Front Panel
The following figure shows the front panel of the ES-3124PWR. The front panel contains switch LEDs, 24 RJ-45
Ethernet ports, four RJ-45 Gigabit ports, 2 mini-GBIC ports, and a console port and a management port for local
switch management.
LEDs
The following table describes the ports on the front panel.
CONNECTOR
24 10/100 Mbps RJ-45
Ethernet Connectors
Four 100/1000 Mbps
RJ-45 Gigabit Ports
Two Mini-GBIC Ports
Console Port
Management Port
3.1.1
Console Port
For local management, you can use a computer with terminal emulation software configured to the following
parameters:
Hardware Connections
Ethernet Ports
Figure 3-1 ES-3124PWR Front Panel
Table 3-1 ES-3124PWR: Front Panel Ports
Connect these ports to a computer, a hub, an Ethernet switch or router.
Connect these 1Gbps Ethernet ports to high-bandwidth backbone network Ethernet
switches or use them to daisy-chain other switches.
Use mini-GBIC transceivers in these slots for fiber-optical connections to backbone
Ethernet switches.
The console port is for local configuration of the switch.
Connect to a computer using an RJ-45 Ethernet cable for local configuration of the
switch.
VT100 terminal emulation
No parity, 8 data bits, 1 stop bit
Dimension ES-3124PWR Ethernet Switch
Hardware Connections
install/remove (optional) modules and explains the LEDs.
RJ-45 Gigabit Ports for stacking
DESCRIPTION
Chapter 3
Console Port
RJ-45 Gigabit / Mini-GBIC
Combo Ports for uplink
9600 bps
No flow control
Management Port
3-1