ZyXEL Communications Dimension ES-3124PWR User Manual page 151

LABEL
Name Enter a descriptive name for this rule for identifying purposes.
Packet Format Specify the format of the packet. Choices are All, 802.3 tagged, 802.3 untagged, Ethernet
II tagged and Ethernet II untagged.
A value of 802.3 indicates that the packets are formatted according to the IEEE 802.3
standards.
A value of Ethernet II indicates that the packets are formatted according to RFC 894,
Ethernet II encapsulation.
Layer 2
Specify the fields below to configure a layer 2 classifier.
VLAN Select Any to classify traffic from any VLAN or select the second option and specify the
source VLAN ID in the field provided.
Priority Select Any to classify traffic from any priority level or select the second option and specify a
priority level in the field provided.
Ethernet Type Select an Ethernet type or select Other and enter the Ethernet type number in hexadecimal
value. Refer to Table 19-3 for information.
Source
MAC Address Select Any to apply the rule to all MAC addresses.
To specify a source, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs).
Port Select the port to which the rule should be applied. You may choose one port only or all
ports (All Ports).
Destination
MAC Address Select Any to apply the rule to all MAC addresses.
To specify a destination, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs).
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP Select Any to classify traffic from any DSCP or select the second option and specify a DSCP
(DiffServ Code Point) number between 0 and 63 in the field provided.
IP Protocol Select an IP protocol type or select Other and enter the protocol number in decimal value.
Refer to Table 19-4 for more information.
You may select Establish Only for TCP protocol type. This means that the switch will pick
out the packets that are sent to establish TCP connections.
Source
IP Address/Address Enter a source IP address in dotted decimal notation.
Prefix
Specify the address prefix by entering the number of ones in the subnet mask.
Socket Number
You must select either UDP or TCP in the IP Protocol field before you configure
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second
option and enter a TCP/UDP protocol port number.
Classifier
Table 19-1 Classifier
DESCRIPTION
the socket numbers.
Dimension ES-3124PWR Ethernet Switch
19-3