Troubleshooting - PALSON VICTORY Operating Instructions Manual

GB
2. Keep bags that have not been used in a cool, dry place.
3. Clean the coffee machine when over-use leads to oiliness. The little drops of oil on the surface of recently made black
coffee are due to the extraction of oil in the powdered coffee.
4. Oiliness can occur frequently if highly roasted coffee is used.

TROUBLESHOOTING

Problem
Water or air leak
from the coffee
preparation area.
The two blue lights
are blinking and the
coffee maker has
stopped making
coffee.
Water is leaking
from the base of
the water tank.
Water is leaking
from the base of
the coffee maker.
10
Cause
The funnel or the bag support is only
partially in place or has been badly
positioned.
The ring seal has been damaged.
There is not enough water in the tank.
The internal tube is blocked.
The coffee nozzle which is located below
the bag support is blocked.
There is too much water in the tank.
The ring seal has been damaged.
The water tank has not been properly
positioned.
The coffee maker's internal tube is
damaged.
The valve ring seal is damaged.
The drip tray contains too much water.
Remedy
Open the preparation area and correctly
position the funnel or the bag support.
Change the ring seal.
Fill the tank with water and press the one cup
or two cup button again to make coffee.
Do not use the coffee maker. Please get in
touch with the authorised technical service
agent to have it repaired.
Stop using the appliance for one hour. Allow
it to cool completely, open the lid and remove
the bag support. Insert a needle with a
diameter of less than 0.7 mm into the opening.
This should clear the blockage and you can
make coffee again.
The water level must be no more than 20mm
from the top of the tank. (Max.level)
Change the ring seal.
Remove the tank and replace it positioning it
correctly.
Do not use the coffee maker. Please get in
touch with the authorised technical service
agent to have it repaired.
Change the ring seal.
Empty and clean the drip tray regularly.