ControlOMatic TECHNICHLOR Operating Instructions Manual page 2

IMPORTANT SAFETY INSTRUCTIONS
READ & FOLLOW ALL INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
WARNING: Remove the TechniChlor from the SPA when using the SPA.
WARNING: Cutting the cord from the power supply to the TechniChlor cell voids the warranty.
Damage will occur if the connection is reversed.
WARNING: To reduce the risk of injury, do not permit children to use this product unless they
are closely supervised at all times.
WARNING: Use TechniChlor only according to these instructions. Any modification or misuse of
this product will void the warranty.
WARNING: Install TechniChlor in accordance with all national and local electrical, plumbing,
safety, and other applicable codes.
WARNING: Connect TechniChlor to a GFCI (ground fault circuit interrupt) or GFI (ground fault
interrupt) protected VAC power source only.
WARNING: Protect the power supply and outlet from exposure to the elements including direct
sun, rain, snow, condensation, etc.
WARNING: DO NOT use with extension cord. Injury may result.
WARNING: DO NOT insert objects into, or tamper with TechniChlor's body in any way.
Inserting metal objects into the body may cause damage and void the warranty.
WARNING: DO NOT operate TechniChlor if damaged in any way.
WARNING: DO NOT pull on the cord to disconnect the Power Supply from power source. Do
not allow the cord be walked on, or to rest on sharp edges or corners. Do not drop, throw, or
otherwise rough handle TechniChlor.
WARNING: DO NOT handle the unit during chlorine production (visible bubbling). Slight
discomfort may be felt in cuts, sores, or sensitive skin areas due to chlorine concentration and
the electrolysis process. Stop chlorine production by either removing TechniChlor from the
water by lifting the cord (do not grasp the housing), or by unplugging the power supply from the
power source.
WARNING: DO NOT operate or leave the power supply in temperatures below 32ºF or 0ºC.
The power supply may not survive in extremely cold temperatures.
WARNING: Disconnect, remove and store TechniChlor indoors when spa has been winterized
or drained.
WARNING: Make sure the power supply is unplugged when cleaning the cell.
CAUTION: Leave spa cover open at least 1 minute to allow trapped gases to escape prior to
use.
CAUTION: Measure water quality parameters and adjust if necessary prior to each spa use.
CAUTION: TechniChlor doesn't measure the chlorine level and must be adjusted properly in
order to not over-chlorinate your spa. Over-chlorination can lead to spa damage and un-healthy
water conditions.
SAVE THESE INSTRUCTIONS