Multichannel Systems; Changing Carrier Frequencies - AKG WMS 40 PRO FLEXX User Instructions

BDA WMS 40 FLEXX 08_Hex:Layout 1
The spacing between the three carrier frequencies of each WMS 40 FLEXX is wide enough
for operating three radio channels simultaneously within the same frequency band with no
mutual interference.
For systems with up to nine channels you will need WMS 40 FLEXX kits in up to three dif-
ferent frequency bands. Please ask your dealer which frequency bands are suited for mul-
tichannel use and approved for the place where you will use the system. Perform steps 1
through 6 for each frequency band separately.
1. Switch power to all transmitters and receivers off.
2. Set the frequency selectors on the transmitter and receiver for channel 1 to "1".
3. Set the frequency selectors on the transmitter and receiver for channel 2 to "2".
4. Set the frequency selectors on the transmitter and receiver for channel 3 to "3".
5. Set up the transmitter and receiver for channel 1.
6. Repeat steps 1 through 5 for channels 2 and 3.
• Never operate two or more wireless channels on the same frequency at the same
time and location. This would cause unwanted noise due to radio interference.
• Prior to changing a carrier frequency, be sure to switch the transmitter off. To activate
the new carrier frequency, switch the transmitter back on.
WMS 40 FLEXX
01/08/2008 15:52
3 Setting Up
Seite 31 (Schwarz/Black Auszug)

3.9 Multichannel Systems

Note:
Refer to fig. 17 on page 100.
Refer to sections 3.1
through 3.8 above.
L
Important!
3.10 Changing
Carrier Frequencies
31