Fcc Statement; Safety And Environment; Safety; Environment - AKG WMS 40 PRO FLEXX User Instructions

BDA WMS 40 FLEXX 08_Hex:Layout 1
L
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Parts 74 and 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC regulations.
Changes or modifications not expressly approved in writing by AKG Acoustics may void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.

1.1 Safety

1.2 Environment

22
01/08/2008

1 Safety and Environment

FCC Statement

1. Do not spill any liquids on the equipment and do not drop any objects through the ven-
tilation slots in the equipment.
2. The equipment may be used in dry rooms only.
3. The equipment may be opened, serviced, and repaired by authorized personnel only.
The equipment contains no user-serviceable parts.
4. Before connecting the equipment to power, check that the AC mains voltage stated on
the supplied AC adapter is identical to the AC mains voltage available where you will
use the equipment.
5. Operate the equipment with the supplied AC adapter with a 12-VDC output. Using
adapters with a different output voltage or current type may cause serious damage to
the unit.
6. If any solid object or liquid penetrates into the equipment, shut down the sound system
immediately. Disconnect the AC adapter from the power outlet immediately and have the
equipment checked by AKG service personnel.
7. If you will not use the equipment for a long period of time, disconnect the AC adapter
from the power outlet. Please note that the equipment will not be fully isolated from
power when you set the power switch to OFF.
8. Do not place the equipment near heat sources such as radiators, heating ducts, or am-
plifiers, etc. and do not expose it to direct sunlight, excessive dust, moisture, rain, me-
chanical vibrations, or shock.
9. To avoid hum or interference, route all audio lines, particularly those connected to the
microphone inputs, away from power lines of any type. If you use cable ducts, be sure
to use separate ducts for the audio lines.
10. Clean the equipment with a moistened (not wet) cloth only. Be sure to disconnect the AC
adapter from the power outlet before cleaning the equipment! Never use caustic or
scouring cleaners or cleaning agents containing alcohol or solvents since these may
damage the enamel and plastic parts.
11. Use the equipment for the applications described in this manual only. AKG cannot ac-
cept any liability for damages resulting from improper handling or misuse.
1. The AC adapter will draw a small amount of current even when the equipment is switched
off. To save energy, disconnect the AC adapter from the power outlet if you will leave the
equipment unused for a long period of time.
2. When scrapping the equipment, separate the case, circuit boards, and cables, and dis-
pose of all components in accordance with local waste disposal rules.
3. The packaging of the equipment is recyclabe. Dispose of the packaging in an appropri-
ate container provided by the local waste collection/recycling entity and observe all local
legislation relating to waste disposal and recycling.
15:52 Seite 22 (Schwarz/Black Auszug)
WMS 40 FLEXX