Connecting A Microphone/Instrument (Pt 40 Flexx) - AKG PT 40 FLEXX User Instructions

PT 40_2008_Hex:Layout 1
3. Set the on/off switch (3) to "ON" to switch power to the bodypack transmitter on.
4. Switch power to the receiver on.
5. a) Talk or sing into the microphone.
b) Play your instrument.
6. Use the screwdriver (1a) integrated in the battery compartment lid (1) to set the GAIN
control (4) to a position where the AF CLIP LED on the receiver will flash occasionally.
7. Replace the battery compartment lid (1) on the transmitter.
1. Set the frequency selector (1) on the transmitter and the frequency selector on the re-
ceiver to the same positions (1 - 1, 2 - 2, or 3 - 3).
If the transmitter and receiver are tuned to different frequencies, no signal will
be received!
2. Remove the battery compartment lid (1).
3. a) Plug the mini XLR connector on the cable of your microphone into the audio input
socket (2) on the bodypack transmitter.
b) Plug the jack plug on the MKG L guitar cable into the output jack on your instrument
and the mini XLR connector on the guitar cable into the audio input socket (2) on the
bodypack transmitter.
4. Set the on/off switch (3) to "ON" to switch power to the bodypack transmitter on.
5. Set the SQUELCH control (6) on the receiver to minimum and switch power to the
receiver on.
6. a) Talk or sing into the microphone.
b) Play your instrument.
7. Use the screwdriver (1a) integrated in the battery compartment lid (1) to set the GAIN
control (4) to a position where the AF CLIP LED on the receiver will flash occasionally.
8. Replace the battery compartment lid (1) on the transmitter.
PT 40 PRO/FLEXX
01/17/2008 09:52 Seite 21 (Schwarz/Black Auszug)
3 Setting Up
See also secttion 4.
3.3 Connecting a
Microphone/Instrument
(PT 40 FLEXX)
Fig. 5: Connecting a micro-
phone or instrument to the
PT 40 FLEXX bodypack.
Refer to fig. 5.
See also secttion 4.
21