Subscribe to Our Youtube Channel
Related Manuals for Vivo DESK-SKIRT-24
Summary of Contents for Vivo DESK-SKIRT-24
- Page 1 24” Cable Management Desk Organizer SKU: DESK-SKIRT-24 Instruction Manual Assembly Video & Product Info www.vivo-us.com/products/desk-skirt-60...
- Page 2 [ THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ]...
- Page 3 If you do not understand these directions, or if you have any doubts about the safety of the installation, please contact our product support team at 309-278-5303 or help@vivo-us.com for further assistance. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury.
- Page 4 Package Contents A (x1) B (x2) C (x2) Panel Side Bar Mounting Clip D (x4) E (x6) Upper/Lower Joining Tube Included Hardware S-A (x2) ST4.8x19mm Screw Tools Needed: Phillips Pencil Drill Screwdriver...
- Page 5 ASSEMBLY STEPS STEP 1 Assemble the steel bar frame using the Side Bars (B), Upper/Lower Bars (D) and Joining Tubes (E). Lighty tap each joint against a hard surface to ensure all bars and joiners are fully pressed in. Ensure all bars and joiners are fully pressed in for a secure fit.
- Page 6 STEP 2 Open the flap and straps of the Panel (A) and insert the frame, making sure the frame is fully inserted and the material is tightly stretched around it. Snug Fit: Fabric on panel has a tight fit around the frame and may need to be stretched before inserting the frame.
- Page 7 STEP 3 Place the Mounting Clips (C) in the center of each exposed portion of the steel bars. Center the assembled panel under the desktop.
- Page 8 STEP 5 Mark the locations of the Mounting Clips (C) using a pencil. Pre-Drilling Instructions Drill mounting holes using illustration below. 9/64” (3.5mm) Drill Bit 0.6” (16mm) Hole Depth...
- Page 9 STEP 6 Mount the assembled panel to the underside of the desk using the ST4.8x19 Screws (S-A) and a Phillips screwdriver as shown. ≥1” WARNING Desktop must be at least 1” thick to prevent screws from poking out through the top and damaging the surface. NOTE Ensure the wire management flap on the Panel (A) is facing the inside of the desktop.
- Page 10 STEP 7 Route and organize the cables and secure them using the flap on the Panel (A).
- Page 11 [ THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ]...
- Page 12 LAST UPDATED: 01/08/24 REV2 Need Help? Get In Touch Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com www.vivo-us.com 309-278-5303 Chat live with an agent! FOR MORE GREAT VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: WWW.VIVO-US.COM VIVO-us @vivo_us...
Need help?
Do you have a question about the DESK-SKIRT-24 and is the answer not in the manual?
Questions and answers