LuxenHome WHF1022 Instruction Manual

LuxenHome WHF1022 Instruction Manual

Modern off white and gray resin bowl outdoor fountain with led light

Advertisement

Product Name:
SKU #:
Thank you for purchasing this LuxenHöme product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure no missing or damaged parts. Do
not attempt to assemble or use the product if any parts are missing or damaged.

CARTON CONTENTS:

Description
Fountain
Pump
Compatible Pumps for this fountain:
Pump Model No.
JR450/LED
JB450/LED
YH707/LED
Tools required for assembly: No tools are required for assembly.

Assembly Instructions:

1. Unpack the box's contents and check to ensure that all items are accounted for and in good condition.
2. Select a flat, level surface for the assembly and final location for your fountain.
3. Insert the water supply tube into the pump outlet from the opening at the back of the fountain. Insert the
LED connector into the pump connector, and twist it to tighten. Place the pump inside the back of the
fountain, and draw the pump power cord out.
4. Add clean water to the fountain. The water level should be approximately 30mm lower than the basin's
edge.
5. Connect the power cable to the outlet. If installed properly, water flow in the fountain will begin shortly.
6. Please do not use the electrical plug in wet weather conditions. Please note: There may be air in the pump
on first use. It may take several minutes until all the air escapes.
7. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed where it
cannot be damaged.
8. When no one is present to observe the performance, do not leave your fountain running for extended
periods.
9. Check the area around your fountain regularly to ensure no leakage.
10. Please refresh the fountain with water each week to ensure it is in good condition.
Modern Off White and Gray Resin Bowl Outdoor Fountain with LED Light
WHF1022
Quantity
1
1
Instruction Manual
SAVE THESE INSTRUCTIONS–This manual contains important
safety and operating instructions for power units.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WHF1022 and is the answer not in the manual?

Questions and answers

Summary of Contents for LuxenHome WHF1022

  • Page 1 Product Name: Modern Off White and Gray Resin Bowl Outdoor Fountain with LED Light SKU #: WHF1022 Thank you for purchasing this LuxenHöme product. This product has been manufactured with the highest standards of safety and quality. PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
  • Page 2 Product Name: Modern Off White and Gray Resin Bowl Outdoor Fountain with LED Light SKU #: WHF1022 11. Do not add harmful chemicals to the water, which may alter the finish. Note: The above diagram is for illustrative purposes only.
  • Page 3 Product Name: Modern Off White and Gray Resin Bowl Outdoor Fountain with LED Light SKU #: WHF1022 MAINTENANCE OF YOUR PUMP: • Keep the water clean – clean water will prolong the life of your pump.
  • Page 4 Product Name: Modern Off White and Gray Resin Bowl Outdoor Fountain with LED Light SKU #: WHF1022 Check the water level regularly to ensure the pump is completely submerged during operation. The pump • should be fully submerged during operation. Do not add water while operating the product. Always disconnect the pump from the power source before adding water.

Table of Contents