Setting Up; Inserting/Replacing And Testing Batteries - AKG GB 40 GUITARBUG User Instructions

Fig. 1: GB 40 controls
GB 40 guitarbug
4 Input Gain: This rotary pot sets the sensitivity
of the transmitter's audio section.
5 Jack plug: 1/4" TS jack plug for plugging the
transmitter directly into an instrument output
jack.
6 Flexible antenna

3 Setting Up

3.1 Inserting/Replacing and Testing
Batteries (refer to fig. 2)
1. Depress the snap hook on the battery com-
partment lid (1).
2. Pull the battery compartment lid (1) down to
remove it from the transmitter.
L
Important!
!
The foam pad on the inside of the bat-
tery compartment lid (1) holds the
battery in place. Do not remove the
foam pad. If you do, the battery will
not be held in place properly and may
cause a rattling noise.
3. If there is a dead or defective battery inside the
battery compartment, remove the battery.
4. Insert the supplied or new battery (2) into the
battery compartment as shown in fig. 2.
5. Set the ON/MUTE/OFF switch (3) to ON.
13