Powered Aire MP Owner's Manual

Air Curtain
Owner's Manual
MP & MP-E | RMP
IMPORTANT! IMPORTANT!
CHECK FOR DAMAGE: When you receive your air curtain, CHECK FOR DAMAGE: When you receive your air curtain,
1.
immediately check for visible or concealed damage. Claims immediately check for visible or concealed damage. Claims
should be made immediately to the transportation com- should be made immediately to the transportation com-
pany. Powered Aire will not be liable for damage claims pany. Powered Aire will not be liable for damage claims
submitted late. submitted late.
2.
LOCATE AND RETAIN THE SERIAL NUMBER: The unit's se- LOCATE AND RETAIN THE SERIAL NUMBER: The unit's se-
rial number is necessary to request technical support, or- rial number is necessary to request technical support, or-
der replacement parts or to acquire a wiring diagram. The der replacement parts or to acquire a wiring diagram. The
serial number is located on a silver sticker located on the serial number is located on a silver sticker located on the
right side end cap when facing the front of the air curtain. right side end cap when facing the front of the air curtain.
For PARTS, TECHNICAL SUPPORT or INFORMATION For PARTS, TECHNICAL SUPPORT or INFORMATION
call: 1-888-321-2473 call: 1-888-321-2473
Models:
Trained and experienced mechanic/electrician required
for installation.
Powered Aire will not be responsible for misplaced Powered Aire will not be responsible for misplaced
switches. switches.
Please review the following instructions for unpacking your air
curtain and preparing it for installation.
1. Remove shrink-wrap and remove wood
2. Using a Phillips head screwdriver, unscrew
the truss head screws that hold intake
screen in place. Set aside screen and screws
for later use. Remove filter (if supplied).
The air curtain is lagged to the bottom of
3.
the crate frame. Use a 3/8" socket with
extension and remove the 4 lag screws (one
in each corner) that attach the air curtain to
the skid. Unit is now ready for installation.
Lag screw holes can be used to bolt the air
curtain to the wall.
4. Replace the intake screen and filter (if
provided) when installation is complete.
Location of Remote Switches
If remote switches are supplied with the MP air curtain
they are shipped in one of the following locations:
Inside
the
junction
box.
2
slats from top and sides of crate.
Inside the
Control
Panel
enclosure (if
supplied).