Bowflex SelectTech 2080 Troubleshooting Manual

3/11/24, 4:59 PM
SelectTech 2080 Barbell: Weights not picked up or selection dials do not
turn
Follow this troubleshooting guide to help resolve issues with selecting weights on the SelectTech 2080 Barbell.
Some common complaints may include:
Selection dials won't turn
Selection dials are stuck
Can't select a weight
Dials turn, but the selection rod does not move
Follow these steps to troubleshoot the issue
1.
Test each dial separately by removing the bar from the base and placing it upside down on the floor. Push in the
release post (reference 1) and turn the selection dial.
If one dial will not turn,
If both dials will not turn,
If both dials do turn, but the selection rod does not move into or out of the housing,
and Housing [12129.C].
2.
If the issue persists, inspect the base and the locking tab (reference 2) for damage. Ensure that they are positioned
properly and oriented in the correct direction. If either the base or locking tabs are damaged or out of position,
a Base [12129.D].
about:blank
SelectTech 2080 Barbell:  Weights not picked up or selection dials do not turn
order a Selection Knob and
order a Curl Bar or Straight Bar
(Reference 1)
Press the release post in (circled in red) while turning the selection dial.
Housing [12129.A].
Handle (whichever bar is affected) [12129.B].
ID: 12129.3
order a Selection Knob
order
1/2