Common Desktop Environment (Cde); Mox Mode Using Cde - Tech Source RAPTOR 1100T - X11R6.1 FOR AIX Installation Manual

For aix

Table of Contents

4.6 Common Desktop Environment (CDE)

Common Desktop Environment (CDE) is available with AIX and is

independent of the Raptor software. In order to use CDE, you need

to configure only /usr/dt/config/Xservers file. The example

below shows how to modify Xservers file to start CDE on Raptor

2100T.

:0 local /usr/x11R6.1/bin/Xtsi –Pll rap2kt0 :0

CDE can be started by typing:

prompt# /usr/dt/bin/dtlogin

In order to enable MOX when using CDE, you must make use of

the StartWin script installed in /usr/X11R6.1/etc. The

Xservers file should be modified as follows:

:0 local /usr/X11R6.1/bin/StartWin:0

Additional command line options can be appended at the end of

this line. The following example StartWin script will start up the

X Server in mox24 mode.

#!/bin/sh

STARSMODE=+mox24

export STARSMODE

pass="/usr/X11R6.1/bin/Xtsi"$*

exec $pass

NOTE: By default, the StartWin script starts up the X Server in

mox24 mode. It can be edited in order to support other MOX

modes.

Chapter 4 - Invoking X11R6.1

4-9

Table of Contents

Do you have a question about the RAPTOR 1100T - X11R6.1 FOR AIX and is the answer not in the manual?