Configuring The Raptor As Lft Display - Tech Source RAPTOR 1100T - X11R6.1 FOR AIX Installation Manual

For aix
Table of Contents

Advertisement

After installing the drivers, reboot the machine.
machine and the AIX should now recognize the Raptor correctly.
You can verify this by entering the following command:
prompt% lsdisp
If a Raptor 2100T card is present in the system, this command
should return an entry like:
DEV_NAME
SLOT
========
====
rap2kt0
02
Note: The Raptor cards are identified by the operating system as
follows:
Raptor 2100T
Raptor 2000-12M
Raptor 2000-24M
Raptor 2000-24M AIX
Raptor 1100T
Raptor 2500T (5MP)
Raptor 2500T (4MP)
Where # is an instance number assigned by the operating system.

3.3 Configuring the Raptor as LFT Display

In order to use the Raptor card as the LFT display, use the chdisp
command to change the current display device to the Raptor
device.
For Raptor 2100T, type the following:
prompt% chdisp [-d|-p] rap2kt0
Chapter 3 – Software Installation
BUS
ADPT_NAME DESCRIPTION
===
========= ===========
pci
rap2kt#
rap2kl#
rap2k#
rap2ki#
rap1kt#
raptfp5#
raptfp4#
3-3
Turn on the
Raptor2kt
Graphics
Adapter

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RAPTOR 1100T - X11R6.1 FOR AIX and is the answer not in the manual?

Table of Contents