SoundPEATS Truengine SE Manual

Package Content

Specifications

Product Diagram

Button Controls

Once connected, the Truengine SE headphones can control meda and phone calls from a phone or tablet.

Wearing the earphones

2. Identify left and right earbud.
3. Adjust earbuds to find the most comfortable place.
4. Insert earbuds to ensure seal well your ear channel.
   

Getting Started

Pairing&Re-pairing

1. Left and right earbud will pair with each other when take out both earbuds simultaneously from charging case with power. Next the ed indicator of left earbud will goes out, and led indicator on right earbud will flash red and white alternately and you can hear voice prompt "pairing", which indicates that earbuds succeed in entering pairing mode.
2. Please find the name of "SOUNDPEATS Truengine SE" on the bluetooth list of your phone, click to connect, you can hear voice prompt "connected" from right earbud. Then you will get a pairing request again, please continue to click "SOUNDPEATS Truengine SE L" to connect.
   
3. SOUNDPEATS Truengine SE Headphones can remember devices previously paired. If you have paired earbuds with a device once, simply activate the bluetooth on your device, take out earbuds from charging case and close the lid, they will automatically reconnect with that device. If earbuds don't automatically connect, select the earbuds name on your bluetooth device to connect.
4. Play in mono mode: Left and right earbud can be used separately when SOUNDPEATS Truengine SE have paired successfully.

Note:

1. When SOUNDPEATS Truengine SE L Headphones request pairing, please select pairing, otherwise earbuds can't be used in mono mode.
2. When SOUNDPEATS Truengine SE Headphones connect with phone equipped with Qualcomm Snapdragon 855 and higher version chipset, there will be two pairing name appeared on the bluetooth list and both of them will automatically connect, you don't need to do the second pairing by manual.
3. If you want to change pairing device but already in "connected" status with previous one, you can force earbuds to enter into pairing mode-only need press the Multifunction button for 5s.

Factory Reset

(Try the following steps if you fail to build connection between two earpieces or earbuds to device)

1. Delete pairing name from your device's bluetooth list.
2. Place both erabuds back into the charging case and ensure that both earbuds are in charging status, press and hold both multifunction buttons for 5s until both indicators flash in white twice. Reset complete.

Charging

SOUNDPEATS Truengine SE are equipped with a charging case which is not only a charging dock to charge the headphones but also a carrying case with built-in rechargeable battery, the charging case can provide up to 3.5 times full charge for both headphones.

Charging the headphones

The headphones are partially charged at the factory. Please make sure they are fu charged before first use.

1. Put the earbuds into corresponding charging slots, make sure the charging contactors are attached.
2. The LED indicators on the headphones turns red to start charging.
3. The headphones are fully charged when LED indicators lights out.

Charging the case

When the charging case is in low battery level, only one white led indicator flashes, please recharge the case:

1. Connect the charging port with USB charging adapter or c.omputer USB port (current less than 5V 1A)
2. Please charge the earphones at least once every 3 months when not in use for a long time.
   

support@soundpeatsaudio.com

www.soundpeatsaudio.com

Documents / Resources

References

• SOUNDPEATS Wireless Earbuds, Bluetooth Headphones, Speakers for Sound.

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download SoundPEATS Truengine SE Manual