SoundPeats Q35 HD+ Manual

Table of Contents

Package Content

Power On	Press and hold the Multifunctional Button for 3s until the led light flashes blue
Power Off	Press and hold the Multifunctional Button for 3s until the led light flashes red
Play / Pause	Short press the Multifunctional button
Volume +/-	Short press the +/-button
Play Next/Previous	Long press the +/- button for 2 seconds
Answer Phone Call	Short press the Multifunctional Button
Hang Up	Short press the Multifunctional Button in an active call
Reject Phone Call	Press the Multifunctional button for 1.5s
Switch Phone Calls	Double Tap the MFB during a call
Activate Voice Assistant	Double press the Multifunctional button while in playing or pausing mode
Factory Reset	Press the Multifunction button for 3s when the headset is charging

Status	Earbuds LED Indicator
Charging	LED indicator is solid red
Fully charged	LED indicator solid blue
Low battery	LED indicator flashes red once every 6 seconds
Reset	LED indicator flashes blue twice quickly

Identify the right and left earpieces.
Insert the earbuds into your ears. Adjust the ear fins direction and put them into your ears.
Adjust each earpiece until it fits flush in your ear and the ear tip seals in the ear canal.

Power on the headset, press and hold the Multifunctional button for approximately 3 seconds until the LED indicator fashes blue quickly (you will hear the voice prompt "power on" first, just keep holding the multifunctional button). Now the headset is in pairing mode.
Activate the Bluetooth on your device and search for the nearby Bluetooth connection:
For iPhone/iPad/iPod: Settings -> Bluetooth -> On
For Android: Setting -> WireIess & Networks -> Bluetooth -> On -> Scan for devices
For Windows Phone devices: Settings -> Bluetooth -> On
"SOUNDPEATS Q35 HD+" should be listed in the search result. Select the name to connect. Once connected, the indicator will be solid blue.

Notes:

When you want to unpair the headset with the device, just press the volume buttons + and - simultaneously for about 3s.
The Q35 HD+ headset will stay in pairing mode for 3 minutes at most if no pairing device is found. Afterwards, it will power off automatically.

Connect the charging port with any USB charging adapter or charging port available. Charging starts automatically with LED indicator turning red and the headset turns off.
The headset is fully charged when the LED indicator turns blue.

Notes:
When charging with a USB adapter, the charging current should not be greater than 1A. Please do no use quick charger to charge the headphones.

Keep the headset away from heat and humidity.
Do not put the product under direct sunlight or hot areas. High temperatures will shorten lifespan of the headset, battery and / or the internal circuit board.
Power off the headset when not in use and before storing.
Do not try to take the product apart.
Do not drop or knock your headset on hard surfaces.
Do not use chemicals or detergents to clean the product.
Do not scrape the surface with sharp objects.