Bowers MOORE & WRIGHT MWT-2105 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Bowers Manuals
  4. Measuring Instruments
  5. MOORE & WRIGHT MWT-2105
  6. Operating instructions manual

Bowers MOORE & WRIGHT MWT-2105 Operating Instructions Manual

Coating thickness gauge non ferrous
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
MWT-2105 Coating Thickness Gauge
Non Ferrous
Operating Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MOORE & WRIGHT MWT-2105 and is the answer not in the manual?

Questions and answers

Related Manuals for Bowers MOORE & WRIGHT MWT-2105

Summary of Contents for Bowers MOORE & WRIGHT MWT-2105

  • Page 1 MWT-2105 Coating Thickness Gauge Non Ferrous Operating Instructions...

  • Page 2: Table Of Contents

    Contents 2. Description 2.1 Gauge Page Page 1 Introduction 4 Setup 2 Description 4.1 Measurement Settings 2.1 Gauge 4.1.2 Upper and Lower Limit Settings 4.1.3 Calibration 2.2 Display 4.2 System Settings 2.3 Specifications 4.2.1 Unit 3 Operation 4.2.2 Backlight 3.1 Power on/off 4.2.3 Key Tone 3.2 Measuring Procedure 5 Calibration and Maintenance...

  • Page 3: Display

    2.3 Specifications In Single Mode, when a measurement is complete, the probe should be lifted and moved to the next measurement point. In this mode, the measurement data can be stored automatically and the mean value can be calculated. Specifications In Continuous Mode, the probe is slid along the measuring surface at it takes points continuously.

  • Page 4: Data Read And Browse

    4 Setup 3.2.5 Data Read and Browse The gauge uses a menu for setting the parameters or the functions. The structure of setup menu is shown in Fig 4-1. Measured Single In the measurement mode, press the Menu to enter the 1.

  • Page 5: Calibration

    5 Calibration and Maintenance 4.1.3 Calibration 5.1 Calibration For a detailed calibration procedure See 5.1 To ensure measurement accuracy, recalibration may be required to compensate for the error caused by wear and tear, or changes in the environment. 4.2 System Settings Press to enter the menu and select Measure, press to select Calibration.

  • Page 6: One-Point Calibration

    5.1.2 One-Point Calibration 5.2 Maintenance Before performing One-point calibration you must first complete Avoid dirt, dust, corrosive substances or harsh chemicals. Take care not to drop the device and a Zero-calibration.(Fig. 5-2) keep the device away from humid environments. After use, place the instrument back into the box or another clean, secure location. Press to select 1st (One-point calibration), the screen will show 0000.0.

Table of Contents