Advertisement
TRIMLINE VEHICLE DOCK FOR PANASONIC
TOUGHBOOK
Description
DOCKING STATION FOR PANASONIC TOUGHBOOK® G2 NPT
DOCKING STATION FOR PANASONIC TOUGHBOOK® G2 DPT
CRADLE FOR PANASONIC TOUGHBOOK® G2
DOCKING STATION FOR PANASONIC TOUGHBOOK® G2 LITE NPT
DOCKING STATION FOR PANASONIC TOUGHBOOK® G2 LITE NPT
Bundles with power adapters included as a kit are available and are indicated with –PS suffix added to the part number.
NOTE: Standard docking stations are not compatible with TOUGHBOOK G2 tablet device's using a hand strap
attached to the rear of the tablet, or an extended battery (Extended Battery Model # FZ-VZSU1UU). Access to
other rear mounted features of the tablet might also be affected (fingerprint reader, smart card reader, HF RFID
reader, and touch pen).
G2 TABLET COMPUTERS
®
USER GUIDE
WWW.PRECISIONMOUNTS.COM
Part Number
AS7.P222.100
AS7.P222.102
AS7.P222.104
AS7.P222.120
AS7.P222.122
515 58th Ave SE, Calgary, Alberta, T2H 0P7
1-888-869-7652 | info@precisionmounts.com
Advertisement
Table of Contents
Related Manuals for PMT AS7.P222.100
Summary of Contents for PMT AS7.P222.100
- Page 1 TRIMLINE VEHICLE DOCK FOR PANASONIC TOUGHBOOK G2 TABLET COMPUTERS ® USER GUIDE Description Part Number AS7.P222.100 DOCKING STATION FOR PANASONIC TOUGHBOOK® G2 NPT DOCKING STATION FOR PANASONIC TOUGHBOOK® G2 DPT AS7.P222.102 AS7.P222.104 CRADLE FOR PANASONIC TOUGHBOOK® G2 AS7.P222.120 DOCKING STATION FOR PANASONIC TOUGHBOOK® G2 LITE NPT AS7.P222.122...
-
Page 2: General Instructions
In order to safely install and use PMT products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brake lines, electrical, drive train or other systems), air-... - Page 3 The power input should be 15.0Vdc / 8 A (120W). The dock is meant to operate on 14.5 Vdc to 16 Vdc. Use a recommended power supply for the dock. Panasonic recommends using a 120W Lind Auto Adapter (PMT part#: PS001) for this dock.
-
Page 4: Description Of Parts
DESCRIPTION OF PARTS Corner clamps Top clamp Tablet power port blocking tab. (not present on cradle versions) RF antennae switch. Switch should only be in the downward 2x Front Facing position when using USB 2.0 external antennas Type-A ports Docking Floating Connector Lock... - Page 5 DESCRIPTION OF PARTS Cable tie rail Bolt Mounting plate Washer attachment screws. Sleeve #10-32 UNF (x4) Washer Mounting plate With VESA 75 hole pattern and ¼-20 hardware WWW.PRECISIONMOUNTS.COM 515 58th Ave SE, Calgary, Alberta, T2H 0P7 1-888-869-7652 | info@precisionmounts.com...
-
Page 6: Port Identification
PORT IDENTIFICATION RF Pass thru connectors (optional) (SMA) CH 1 CH 2 USB 2.0 Type-A (x2) Power in USB3.2 15 Vdc 5Gbps HDMI (x2) Note: Type-A (x2) Use of HDMI cable Serial with ferrite bead is Ethernet RJ45 RS-232 necessary 10/100/1000 Mbps WWW.PRECISIONMOUNTS.COM 515 58th Ave SE, Calgary, Alberta, T2H 0P7... -
Page 7: Installation Instructions
INSTALLATION INSTRUCTIONS Step 1 Using a 1/8” Allen/Hex key (wrench), remove the mounting plate from the dock. Step 2 Install mounting plate onto mounting infrastructure via the VESA 75 interface and the provided hardware. Be sure to orientate the plate in the correct position as the access hole for the RF switch must line up with the switch on the dock once installed. - Page 8 INSTALLATION INSTRUCTIONS Docking the Tablet Step 1 Ensure lock is in the unlocked position Step 2 Place tablet bottom edge first against the docking connector. Ensure the tablet is centered in the dock. Step 3 a. Press the Middle of the Tablet DOWN against the Floating Connector, and b.
- Page 9 INSTALLATION INSTRUCTIONS Un-docking the Tablet Step 1 If previously locked, insert key and rotate lock to the unlocked position. Push clamp up Step 2 a. Using your thumb, push Top Clamp b. Then pull the top of the tablet away from the dock.
- Page 10 Regulatory model: AS7.P222.102 Certifications and test standards: EN ISO / IEC 17050-1:2010 CSA C22.2 NO. 62368-1 UL 62368-1 ICES-003(A) / CISPR 32 / EN 50498 ISO 10605 MIL-STD-810G: CHG1 RoHS 3 (2015/863) Made in Canada This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions.
Need help?
Do you have a question about the AS7.P222.100 and is the answer not in the manual?
Questions and answers