Label Sensor Adjustment - SATO M-8400RV Operator And Technical Reference Manual

Section 2. Installation and Configuration

LABEL SENSOR ADJUSTMENT

The Label Sensor Assembly can be positioned to match the location of the label
registration hole/gap/edge. The diagram below illustrates the relative position of
each sensor along the Label Sensor Unit and its range of movement. To position the
sensors, use the adjustment knob located outside and below the print head assembly.
Eye-Mark
on bottom
of liner
Page 2-14
Reflective Sensor
14mm
min
Reflective
7mm to 54 mm
Label Gap
17mm to 64mm
The range of sensor adjustment can be
increased to allow the Gap sensor to be
positioned as close as 3mm from the inside label
edge. Contact SATO for information on how to
make this modification.
9001041 Rev. D
Label Gap Sensor
SATO M-8400RV