Table of Contents
Advertisement
Driver installation and settings (Macintosh)
Mac OS 9 users
1
With the GT-PRO disconnected, start up Mac OS.
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit it as well.
3
After starting up Mac OS, select Apple System Profiler from the Apple menu.
The Apple System Profiler dialog box will appear.
fig.12-0410
4
Click the Devices and Volumes tab.
5
Before connecting the USB cable, switch the GT-PRO's driver mode to "Standard."
For instructions on switching the GT-PRO's driver modes, refer to "Switching the Driver
Mode" (p. 88).
6
With the power switch turned OFF, use the USB cable to connect the GT-PRO to your
computer.
7
Make sure that the GT-PRO's OUTPUT MAIN and SUB knobs are set to the lowest setting,
then switch ON the POWER switch.
Wait for approximately five seconds.
While you are waiting, the screen display will not change, but the GT-PRO is being detected.
Do not touch the mouse or keyboard.
8
In order to check that detection has been completed, once again go to Apple System Profiler,
and select Update all information from the Commands menu.
In the USB area, three audio devices will be displayed.
If these are displayed correctly, driver installation has succeeded.
fig.11-630
9
In the File menu, click Quit to close the Apple System Profiler.
If they are not displayed correctly, disconnect the GT-PRO, wait for about ten seconds, and
then repeat the procedure from step 2.
138
Advertisement
Table of Contents
