Turning Off The Br-1600Cd - Boss BR-1600CD Basic Operation Gude

Turning off the BR-1600CD

1
If an amplifier or any other similar
device is connected to the BR-1600CD's
output, this should be turned off first
of all.
2
Press and hold down the BR-1600CD's
POWER switch for approximately 2
seconds.
The message "Shutdown OK?" will appear.
fig.07-04ad
(IMPORTANT) Precautions when turning off the BR-1600CD
• Always use the POWER switch to turn off the BR-1600CD's power. Recorded audio data, mixer settings, etc. are not
stored as the corresponding operations are completed; rather, they are stored when the song is saved or when the
power is turned off automatically. Therefore, when the BR-1600CD is turned off by pulling out the AC adaptor's plug
or by any other method not involving the POWER switch, all recorded audio data, mixer settings, and the like will be
lost. This practice can also lead to song data being lost or to the hard disk being permanently damaged, and it should
be avoided.
• Before removing the AC adaptor from the power outlet, be sure to confirm that the BR-1600CD has turned off fully
(i.e., the display is not lit). The AC adaptor should not be disconnected while data is being saved as this will result in
the loss of recorded audio data and other song contents (i.e., mixer settings, effect patch data, etc.).
• The hard disk motor will continue to run for a short period of time after the power has been turned off. Accordingly,
the BR-1600CD should not be moved immediately after it has been turned off. Note that failure to observe this
precaution can result in damage to the hard disk mechanism.
What is meant by saving songs?
In the BR-1600CD, recorded or edited audio data is only temporarily stored on the hard disk until the song that
contains it is saved. For this reason, if the power is turned off before the song has been saved, all of your recorded and
edited data will be lost. The Save function prevents this from occurring by storing the recorded and edited data on the
BR-1600CD's hard disk.
Note that songs can be saved at any time, not only when the power is being turned off. For more detailed information,
refer to "Saving your song (Song Save)" (p. 56).
Turning on/off the BR-1600CD
3
Press [ENTER/YES].
The message "Save Current?" will appear.
Song Protect is activated for the demo songs already
included in the BR-1600CD at the time of purchase,
and for this reason, the power will turn off without
the message "Save Current?" being displayed.
4
Press [ENTER/YES] once again.
The message "Storing Current..." will appear and
saving of the currently selected song will begin. When
saving has been completed, the message "Now
shutdown..." is displayed, and the BR-1600CD will
automatically turn off a few moments later.
If you do not want to save your song at this time,
press [EXIT/NO]. The BR-1600CD will turn off
without the song being saved. In such a case,
however, all audio that was recorded and data that
was edited since you last saved the song will be lost;
accordingly, be careful not to press [EXIT/NO] by
mistake.
9