Ricoh Aficio CL3000 Maintenance Manual page 382

Direct Printing Port
The direct printing port allows printing directly from a computer, connected to the network, to the printer.
Use the diprint command to change the direct printing port settings.
View settings
The following command displays the current direct printing port settings.
msh> diprint
Example output:
port 9100
timeout=300(sec)
bidirect off
• The "Port" specifies the port number of the direct printing port.
• The "bidirect" setting indicates whether the direct printing port is bidirectional.
Setting timeout
You can specify the timeout interval to use when receiving data from the network.
msh> diprint [0~65535]
Note
The factory default is 300 seconds.
If 0 is set, timeout is disabled.
Bidirectional configuration for the direct printing port
Use this setting to configure whether the direct printing port is bidirectional.
The factory default is "off".
msh> diprint bidirect {on|off}
Operating Instructions Administrator Reference
196