cecotec PURE AROMA 300 YANG - Aroma Diffuser Manual

Also See for PURE AROMA 300 YANG:

Instruction manual (11 pages)

Instruction manual (56 pages)

Table of Contents

Contents

1 PARTS AND COMPONENTS
2 BEFORE USE
3 OPERATION
- 3.1 Light button
- 3.2 On/Off/Timer button
4 CLEANING AND MAINTENANCE
5 TROUBLESHOOTING
6 TECHNICAL SPECIFICATIONS
7 TECHNICAL SUPPORT AND WARRANTY
8 Documents / Resources
- 8.1 Download manual

cecotec PURE AROMA 300 YANG - Aroma Diffuser Manual

PARTS AND COMPONENTS

Steam outlet
Top cover
Timer On/Off
Light
Base
Power socket
Water tank
Air inlet

BEFORE USE

Take the product out of the box and remove all packaging materials.
Make sure all parts and components are included and in good conditions. If any sign of visible damage is observed, contact immediately with our official Technical Support Service.

OPERATION

Place the product on a flat surface and remove the upper lid. Fig. 2.
Connect the adapter to the product's socket. Fig.3
Use a measuring cup to pour water inside the water tank. Then, add 2-3 drops of essential oil per each 100 ml. Fig.4
Use the upper lid to close the unit again. Fig.5
Connect the power adapter to a power supply.

Light button

Press the button once to turn on the product's light. The colour will change from one to another automatically.
Press again to set the current colour steady.
Hold down the button to turn the light off.

Fig.6

On/Off/Timer button

Press the button to activate the mist. The yellow light will turn on.
Press the button again to select the timer: 1 h, 3 hrs, off.
Long press the button to turn the unit off. Fig.7
If the product is knocked or tipped over:

Unplug the cord from the power supply.
Remove the upper lid and pour out the remaining water from inside.
Gently shake the unit and allow it to dry naturally for, at least, 24 hours. Fig.8

information Note
If the device runs out or there is not enough water, the diffuser and its light indicators will automatically turn off.

Do not add water while the product is operating.
Do not use water over 40 ºC.

CLEANING AND MAINTENANCE

After each 5-6 uses, follow the below steps to clean it:
Unplug the product from the power supply and remove the upper lid.
Pour out any remaining water through the emptying nozzle.
Use a soft, damp cloth with some cleaning agent to clean the diffuser's outside.
If the inside part is dirty, remove the inner cover to clean it.
Do not use alcohol or abrasive detergents to clean the product as these could damage the surface.
If the product is not going to be used for a long time, pour out the remaining water and store it in a safe place.

Do not pour the remaining water through the air inlet or any other part. Water can only be poured through the water outlet in order to avoid product damage.
Fig.9

TROUBLESHOOTING

Problem	Cause	Solution
The unit does not turn on or off	There is not enough water in the tank.	Add water to tank.
The unit does not turn on or off	The power cord is not properly plugged.	Disconnect the power cord, check the cord and connect it again.
The product does not emit steam/emits unusual steam	Not enough or too much water in the tank.	Add the correct amount of water (do not exceed the max. mark).
	The water tank is dirty.	Follow the "Cleaning and maintenance" steps.
	The air inlet or the product's base is dirty.	Clean both the air inlet and the product's base in order to remove blockages.
Water leaks	The upper lid and the inner cover are not fixed properly.	Remove the upper lid and the inner cover so mist can be released and installed them back in their correct position.
Water leaks	Temperature is too low or there is too much humidity and steam condenses, forming water droplets.	Do not operate the product under humid or extremely cold conditions.

TECHNICAL SPECIFICATIONS

Product reference: 05282

Product: Pure Aroma 300 Yang

Power: 15,6 W

Voltage and frequency: 100-240 V, 50/60 Hz

TECHNICAL SUPPORT AND WARRANTY

This product is under warranty for 2 years from the date of purchase, as long as the proof of purchase is submitted, the product is in perfect physical condition, and it has been given proper use, as explained in this instruction manual.

The warranty service covers every manufacturing defects of your appliance for 2 years, based on current legislation, except consumable parts. In the event of misuse, the warranty will not apply.

If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact Cecotec Technical Support Service at +34 963 210 728.