Comfee CVU30W2AST - Range Hood Manual

Install the Product

If present, remove all protective polyfilm from the hood and/or parts. This product can be installed in two different ways (Wall-mounted and Top-mounted ). Below picture shows the 1:1 hole drawing of different installation methods.

Wall-mounted

1. When using the outside row, step 1 requires the installation of the front stop, Step 2 assemble the 7'' adapter to the top of the whole machine
   
   1. Disconnect power.
      
      1. White wires
      2. Black wires
      3. Green ground wire
      4. UL listed wire connector
      5. Home power supply cable
      6. UL listed or CSA approved 0.5" strain relief
   2. Use UL listed wire connectors and connect white wires (A) together.
   3. Use UL listed wire connectors and connect black wires (B) together.
2. According to the 1:1 hole drawing of Way1, Drill four Ø0.39" holes on the wall, install the wall plug(this step can be ignore if the wall is wooden and instead to use screws to install directly, no need to drill.), insert the upper
   
3. Put the cooker hood onto the top two screws, and lock the self tapping screws tight;
   
4. Lock the lower two holes with 0.2" * 0.75" screws.
   

Top mounted

1. According to the 1:1 hole drawing of top mounted, mark the following position swith pencil under the cabinet, and use the drilling tool to open the air pipehole and power cord hole in turn.
   
2. Methods for ventilation, "vertical ventilation". Please pay attention to the ventilation method when installation.
   Vertical ventilation: See Pic A, please use tool take out the round cover before using, and the air can be vented from top;
   
   
3. Install the air outlet assembly on the circular air outlet at the back of the cook hood;
   
4. Align the air ventilation port of the cook hood with the cabinet ventilation hole at the bottom, pass the power cord through the power hole, and then use four 0.2*0.75'' screws to lock into the corresponding position of the pencil marked in the cabinet to fix the cook hood.
   

NOTE:

• The extensible pipe are optional accessory, not supplied.
• Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight.
• Make sure the damper assembly (or round duct plate) enters the ductwork and that the damper opens and closes freely.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Comfee CVU30W2AST - Range Hood Manual