Page 1
Simply text a picture of your proof of purchase to: 1-844-224-1614 *The warranty extension is for the three months immediately following the completion of the product’s original warranty period. MODEL NUMBER CVG30W9AST CVG36W9AST...
Page 3
INTENDED FOR RESIDENTIAL COOKING USE ONLY READ ALL INSTRUCTIONS BEFORE INSTALLATION AND USE WARNING CAUTION IMPORTANT WARNING alerts you to situations that may IMPORTANT indicates installation, operation, CAUTION indicates a potentially hazardous maintenance or valuable information that is not cause serious body harm, death or property situation which, if not avoided, may result in damage.
INSTALLATION PREPARATION 1. SELECT INSTALLATION TYPE A. Vented Installation B. Non-Vented / Recirculation Installation A. Vented Installation Roof Discharge This canopy hood is designed for venting through the roof or wall. A 6" round vent system is needed for installation (not included).
INSTALLATION PREPARATION 10.5" 2" min. 9.49" Vent and power Vents and electrical should supply cable entry location be installed in the gray 10.5" shaded areas to provide a clean finished look 20" min. Side Side cabinet cabinet 30" or 36" Centerline Cooking surface CAUTION...
INSTALLATION Hood Mounting Screw Installation 1. Determine and mark the centerline on the wall where the hood will be installed. 2. Select a mounting height between a minimum of 25.6'' and a suggested maximum of 29.53'' above the range to the bottom of the hood. Mark a reference line on the wall.
Page 9
INSTALLATION WALL DRILLING AND BRACKET FIXING (2.36'') (2.36'') (2.36'') (2.36") (3.15'') (3.15'') Chimney 4.69'' 15.75"+15.35'' 17.64''-30.83'' Vertical reference line As a first step, proceed with the following drawings: A veritcal line up to the ceiling or up to the upper limit, at the center of the area in which the ...
Page 10
Assemble the Lower Chimney Cover: • Slide the Lower Decorative Chimney trim (2.1) over the fan body. • Ensure that the Decorative trim is pressed down to line up the lower mounting holes (A) Insert 2 short sheet metal screws (12) in the lower holes •...
B. Non-Vented / Recirculation Installation Recirculation Mode: • Install Carbon Filters. • Install deflector according to your installation environment. Install Upper Decorative Chimney : • Install Chimney mounting bracket (21) at holes previously marked on level D. • Slide the upper decorative chimney 2.2 up to the horizontal line D.
Page 12
Speed adjustment. Turn the Motor and Lights ON. W W h h e e n n Change the motor speed circularly W W h h e e n n Gestures Enter delayed shutdown mode W W h h e e n n (Automatic shutdown after 3 minutes) Turn the Motor and Lights OFF W W h h e e n n...
MAINTENANCE GREASE FILTERS CLEANING METAL SELF-SUPPORTING GREASE FILTERS The filters must be cleaned frequently and can be washed in a dishwasher or a hot detergent solution. Depress the latch to remove the filters. Avoid bending the filters when washing, and allow the filters to ...
Page 14
LIGHTING LIGHT REPLACEMENT Replacing the light modules The entire light module must be replaced. Before changing the light module(s), unplug the appliance or switch off the circuit breaker in the fuse box. Remove the grease filter and carefully remove the 4 screws from each side on the opening (a Phillips head screwdriver will be needed to remove the screws).
1 YEAR LIMITED WARRANTY This is the only express warranty for this product and is in lieu of any other warranty or condition. This product is warranted to be free from defects in material and workmanship for a period of one (1) year from the date of original purchase. During this period, your exclusive remedy is repair or replacement of this product or any component found to be defective, at our option;...
Need help?
Do you have a question about the CVG30W9AST and is the answer not in the manual?
Questions and answers