Pioneer VSX-1021-K Operating Instructions Manual page 78

13 Additional information
Symptoms Causes
Cannot listen to Internet radio The firewall settings for compo-
stations. nents on the network are cur-
rently in operation.
You are currently disconnected
from the Internet.
The broadcasts from an Internet
radio station are stopped or
interrupted.
The Home Media Gallery can- The remote control is not cur-
not be operated with the but- rently set to the Home Media
tons on the remote control. Gallery mode.
SIRIUS radio messages
Status messages Causes
Antenna Error The SIRIUS antenna is not prop-
erly connected.
Check Sirius Tuner The SiriusConnect
properly connected.
Acquiring Signal The SIRIUS signal is too weak at
the current location.
Unit is updating subscription.
Subscription Updating
Updating Channels Unit is updating channels.
Invalid Channel Selected channel is not available/
does not exist.
Firmware Updating The SiriusConnect
firmware is being updated.
78
En
Remedies
Check the firewall settings for components
on the network.
Check the connection settings for com-
ponents on the network, and consult with
your network service provider if necessary
(page 66).
There are cases where you cannot listen
to some Internet radio stations even when
they are listed in the list of Internet radio
stations on this receiver (page 39).
Press HMG to set the remote control to the
Home Media Gallery mode (page 38).
Remedy
Check that the antenna cable is attached
securely.
TM
tuner is not Check that the 8 pin mini DIN cable and AC
Adapter are attached securely.
Check for antenna obstructions and reposi-
tion the SIRIUS antenna to get better signal
reception. Use the Antenna Aiming option
to optimize the antenna position.
Wait until the encryption code has been
updated.
Wait until the encryption code has been
updated.
Select another channel.
TM
tuner's Wait for updating to finish.
Wireless LAN
Status messages Causes
Network cannot be accessed Wireless LAN converter's power
via wireless LAN. is not on. (Wireless LAN convert-
er's "Power", "WPS" and "Wire-
less" indicators are not all lit.)
WLAN POW ERR is displayed on
the receiver's display window.
The LAN cable is not firmly con-
nected.
Wireless LAN converter and base
unit (wireless LAN router, etc.)
are too far apart or there is an
obstacle between them.
There is a microwave oven or
other device generating electro-
magnetic waves near the wire-
less LAN environment.
Multiple wireless LAN converters
are connected to the wireless
LAN router.
Remedy
Check that the USB cable connecting the
wireless LAN converter to the receiver's DC
OUTPUT for WIRELESS LAN terminal is
properly connected.
There is a problem with the wireless LAN
converter's power supply. Turn the receiv-
er's power off, then disconnect the USB
cable, reconnect the USB cable and turn
the receiver's power back on.
If WLAN POW ERR is still displayed after
repeating the above procedure several
times, there is a problem with the receiver
or the USB cable. Unplug the receiver
from the wall and call a Pioneer authorized
independent service company.
Firmly connect the LAN cable (page 22).
Improve the wireless LAN environment by
moving the wireless LAN converter and
base unit closer together, etc.
Use the system in a place away from micro-
wave ovens or others device generating
electromagnetic waves.
Avoid using devices generating electro-
magnetic waves as much as possible when
using the system with the wireless LAN.
When connecting multiple wireless LAN
converters, their IP addresses must be
changed. For example, if the wireless LAN
router's IP address is "192.168.1.1", set the
first wireless LAN converter's IP address to
"192.168.1.249", the second wireless LAN
converter's IP address to "192.168.1.248",
using values between 2 and 249 (such as
"249" and "248") that are not assigned to
other wireless LAN converters or to other
devices.