Playback; Playback Procedure - Pioneer DVR-RT300 Operating Instructions Manual

Playback

Chapter 5
Playback

playback procedure

DVD-Video VR mode Video mode
Preparation:
• Turn ON the TV and set to the video input mode.
• Press DVD/VCR to select the DVD mode. (The DVD
indicator will light.)
1 Press OPEN/CLOSE.
The disc tray will open.
2 Place a disc onto the tray.
Hold the disc, position it with the printed label side up,
align it with the guides, and place it in its proper
position.
DVD-R CD
3 Press OPEN/CLOSE to close the disc tray.
"READING" appears on the screen and some discs start
playback automatically.
• A menu screen may appear on the TV screen, if the
disc has a menu feature. In this case, press
, or ENTER to operate a menu feature.
4 Press PLAY to start playback.
5 Press STOP to end playback.
• The DVD/VCR memorizes the stopped point, depending
on the disc. " " appears on the screen for approx. 4
seconds. " " keeps blinking in the display until the
playback is stopped completely. Press PLAY to resume
playback (from the scene point).
• If you press STOP again ("
screen), the DVD/VCR will clear the stopped point.
6 Then press OPEN/CLOSE.
The disc tray opens. Remove the disc and press
STANDBY/ON.
The disc tray closes automatically and the DVD/VCR
turns off.
Note
• If a non-compatible disc is loaded, "INCORRECT
DISC", "REGION CODE ERROR" or "PARENTAL
ERROR" will appear on the TV screen according to
the type of loaded disc. In this case, check your
disc again (See pages 9 and 25).
• Some discs may take a minute or so to start playback.
• A prohibition symbol " " may appear at the upper
right of the screen. This symbol means either the
feature you tried is not available on the disc, or the
DVD/VCR can not access the feature at this time.
This does not indicate a problem with the DVD/VCR.
• When you set a single-faced disc label downwards
(ie. the wrong way up) and press PLAY or OPEN/
CLOSE, "READING" will appear and then it will
change to "NO DISC".
• Some playback operations of DVDs may be
intentionally fixed by software producers. Since this
DVD/VCR plays DVDs according to the disc
contents the software producers designed, some
playback features may not be available. Also refer
to the instructions supplied with the DVDs.
• When playing DTS-encoded Audio CDs, excessive
noise will be heard from the analog stereo outputs.
To avoid possible damage to the audio system, the
consumer should take proper precautions when
the analog stereo outputs of the DVD/VCR are
connected to an amplification system.
, ,
" appears on the
05
33
En