Related Manuals for ActivePure activTek INDUCT 500 + OZONE
Summary of Contents for ActivePure activTek INDUCT 500 + OZONE
- Page 1 I N D U C T 5 0 0 + O Z O N E SINGLE ROOM AIR PURIFICATION SYSTEM READ MANUAL CAREFULLY FOR PROPER USE AND OPTIMAL OPERATION.
-
Page 2: Table Of Contents
GENERAL INFORMATION PRODUCT OVERVIEW Congratulations on your purchase of the activTek Induct 500+ Ozone air purification enhancement system! The activTek Induct 500+ Ozone utilizes tested ActivePure Technology to substantially reduce odors, visible smoke ® in the air, and treat contamination on surfaces. The activTek Induct 500+ Ozone designed to be installed inside the ductwork of an in-wall heating and air conditioning unit. -
Page 3: Important Safety Instructions
If the unit is hard wired, be sure the power to the unit is off; always follow OSHA electrical lockout safety requirements to prevent accidental release of energy during service or maintenance activities • Never attempt to check operation of the ActivePure Cell Assembly by direct observation; severe eye ®... -
Page 4: Product Features
PRODUCT FEATURES It is important to be familiar with the parts of the activTek Induct 500+ Ozone. If any parts are missing, contact your sales representative or Distributor. Fastener Locations ActivePure Matrix ® (Honeycomb) Power Connection Power Supply INSPECTION 1. Remove unit from shipping carton. -
Page 5: Installing The Unit
INSTALLING THE UNIT • Disconnect power to the AC unit at the breaker or fuse panel before installing unit • It is recommended that this unit be installed by a licensed HVAC contractor to WARNING ensure proper installation and protect your warranty 1. -
Page 6: Cleaning And Maintenance
Disconnect Power from the Induct 500+ Ozone before servicing WARNING The Induct 500+ Ozone unit requires periodic cleaning of the ActivePure Honeycomb Matrix surface and replacement of the ActivePure Bulb once every 12 CAUTION months. It is recommended to vacuum the ActivePure Cell (Honeycomb matrix) surface monthly. -
Page 7: Replacing The Activepure Bulb
Disconnect Power from the Induct 500+ Ozone before servicing WARNING For optimal performance and to maintain the Limited 5 year warranty, it is required to replace the ActivePure Cell Blub once every 12 months, even if the ActivePure Bulb ® CAUTION appears to be operating normally. -
Page 8: Replacement Parts & Service
REPLACEMENT PARTS & SERVICE Use only replacement parts recommended by the manufacturer. WARNING REPLACEMENT PARTS PART NUMBER ActivePure Bulb (Ozone Free) with Honeycomb 9950206 ActivePure Bulb (Ozone) with Honeycomb 9950208 Power Supply (US) 49873 Power Supply (Euro) 49874 ActivePure Bulb with Honeycomb... -
Page 9: Warranty Information
KIND. ALL OTHER WARRANTIES OF ANY KIND, Bulb cycles “ON and OFF” with the system fan, the EXPRESS OR IMPLIED, ARE HEREBY EXPRESSLY ActivePure Bulb is only covered by a ninety (90) day DISCLAIMED, INCLUDING ANY IMPLIED WARRANTY warranty from the date of purchase. -
Page 10: Fcc Declaration & Responsible Party
Model: A1030B reasonable protection against harmful interference in a residential installation. Produced by: ActivePure Manufacturing, LLC This equipment generates, uses, and can radiate radio frequency energy, and if not This device complies with Part 15 of the FCC Rules. installed and used in accordance with the... - Page 12 For information regarding the use of this product, please call Customer Service at 866.736.0503 or email at Support@ActivTek.net. activTek Environmental, LLC 1300 Valley Drive Bristol, VA 24201 866.736.0503 Assembled in U.S.A. | © activTek Environmental, LLC. All Rights Reserved...
Need help?
Do you have a question about the activTek INDUCT 500 + OZONE and is the answer not in the manual?
Questions and answers