Page 1
SPLIT TYPE ROOM AIR CONDITIONER OPERATION MANUAL INDOOR UNIT OUTDOOR UNIT AH-X10 Series AU-X10 Series AH-X13 Series AU-X13 Series AH-X15 Series AU-X15 Series AH-X18 Series AU-X18 Series AH-X20 Series AU-X20 Series AH-X24 Series AU-X24 Series AH-X25 Series AU-X25 Series Uses Refrigerant B129_EN.indd 1...
AUXILIARY MODE Use this mode when the remote control is not available. Remove the battery cover. TO TURN ON Insert two batteries. Press the ON/OFF button. Reinstall the battery cover. Press the RESET button using a thin stick. TO TURN OFF Press the ON/OFF button again.
BASIC OPERATION Press the MODE button to select the operation mode. Press the ON/OFF button to start oper- ation. TO TURN OFF Press the THERMOSTAT button to set the desired temperature, you can set temper- ature in 0.5 ° C increments. Press the FAN button to set the desired fan speed.
SUPER JET OPERATION DIRECTION The air conditioner works at the maximum power and optimum louver direction to make the room cool rapidly. During operation, press the SUPER JET button. TO CANCEL HORIZONTAL AIR FLOW DIRECTION NOTE: EN-6 B129_EN.indd 6 2021/11/11 13:11:03...
BABY MODE OPERATION ECO MODE OPERATION The air conditioner will operate with Soft , quiet and clean operation cools a room with well optimized for infants. lower power consumption than usual in this mode. During operation, press the BABY During operation, press the ECO MODE button.
TIMER OPERATION OFF TIMER ON TIMER Press the OFF TIMER button and set Press the ON TIMER button and set the time as desired. the time as desired. TO CANCEL TO CANCEL NOTE: TIMER ON EN-8 B129_EN.indd 8 2021/11/11 13:11:04...
BEST SLEEP OPERATION MAINTENANCE For more comfortable sleep, temperature Be sure to disconnect the power cord from the wall outlet or turn off the circuit breaker and fan speed will be controlled automati- before performing any maintenance. cally by the best program. During operation, press the BEST Turn off the unit.
Page 12
The following conditions do not denote Check the following points before equipment malfunctions. calling for service. UNIT DOES NOT OPERATE The unit does not operate The unit does not cool effectively ODORS The unit does not receive the remote control signal MIST SEEN AT INDOOR AIR OUTLET THE OUTDOOR UNIT DOES NOT STOP Please call for service when the green...
Page 13
Press the FAN button once, the remote ABOUT ERROR CODE control will display “ ”. Example Example Press the THERMOSTAT button “ ” Press the THERMOSTAT button “ ” and “ ”, remote control display for over 5 seconds on remote control will change from “...
Need help?
Do you have a question about the AH-X10 Series and is the answer not in the manual?
Questions and answers