Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hyundai power products HTDE1200
Summary of Contents for Hyundai power products HTDE1200
-
Page 2: Table Of Contents
Warning: Please read this manual carefully before using the equipment! CONTENTS GENERAL SAFETY INSTRUCTIONS……………………………3 TECHNICAL DATA………………………………………………...11 ASSEMBLY…………………………………………………..……..13 OPERATION………………………………………………..………15 MAINTENANCE AND STORAGE……………………..………...18 DECLARATION CE………………………………………………..21 Page... -
Page 3: General Safety Instructions
GENERAL SAFETY INSTRUCTIONS A) LEARNING Please read the operating instructions carefully. Familiarize yourself with the controls and proper use of the device. Never allow children to use the device. Never allow persons unfamiliar with the operating instructions to operate the device. -
Page 4: Warnings And Hazards
Wear protective glasses during use. Wearing a mask is recommended to prevent dust irritation. Before use, always perform a visual inspection, especially of the blade, making sure that the screws and knife assembly are neither worn nor damaged. Replace worn or damaged blades and all screws to maintain balance. - Page 5 the equipment. The permanent connection of any electrical device in a building should be performed by a qualified electrician, in accordance with current electrical standards. A wrong connection can cause serious injury or death. Before connecting the device, check that the sockets and extension cords are in good condition.
- Page 6 Never pull the lawnmower by its power cable and never pull on the power cable to remove it from the socket. Do not expose the cable to heat sources. Do not allow it to come into contact with solvents, oil, fuels or sharp objects.
- Page 7 defective guards or without safety devices, such as a deflector or grass catcher, which are not in place. On trailed or powered models, disengage before starting the engine. Turn the engine on with the engine switch on, carefully as instructed, and with your feet well away from the blade.
- Page 8 Before adjusting the cutting height of the grass. When mowing, always keep a safe distance from the rotating blade. This distance corresponds to the length of the handlebar. After a failure, immediately stop the engine, do not go on mowing, take the machine to an authorized service centre and ask for qualified personnel to solve the problem.
- Page 9 the cable from the socket before any intervention. Wear sturdy gloves when removing and reassembling the blade. Check the balance of the blade after sharpening. For safety reasons, do not use the mower with worn cables or damaged parts. ...
- Page 10 Risk of splashing; keep people away. This product is doubly electrically insulated. Beware of sharp blades. The blades continue rotating after the engine has stopped. Unplug device from mains before maintenance, i.e. if the power cord is damaged. Guaranteed level of sound emission Keep the power cord away from cutting tools.
-
Page 11: Technical Data
TECHNICAL DATA a) Parts list 1. Upper handle 2. Lower handle 3. Switch box 4. Grass collection compartment 5. Wheels 6. Motor protection 7. Cable hook 11 | Page... - Page 12 b) Technical data - Voltage: 230-240V~50Hz - Power index: 1200W - No-load speed: 3450min - Cutting height: 25/45/65mm - Cutting width: 320mm - Protection class: II - Degree protection: IPX4 - Net weight: 8.9 kg Sound pressure level LpA (measured at the operator level according to EN836): 80.1 dB(A), k=3dB(A) Sound power level (measured according to European Directive 2000/14/EC: 92.2 dB(A), K=2.02dB(A)
-
Page 13: Assembly
ASSEMBLY INSTRUCTIONS CUTTING HEIGHT ADJUSTMENT To obtain the desired cutting height, the front and rear axles are repositioned on the underside of the mower housing. Warning! Disconnect the mower from the power supply and ensure the blade has stopped coasting before adjusting the height. - Page 14 1. To adjust the front wheel cutting height position (fig. 2a) 1) Turn the mower upside down. 2) Pull the wheel axle towards the front of the mower. 3) Locate the wheel axle into the desired cutting height adjustment position. Note: Make sure that both front right and left wheels are located in the same cutting height adjustment position.
-
Page 15: Operation
Note: Make sure that both rear right and left wheel are located in the same cutting height adjustment position. 3. Cutting height positions (fig.2c) 25mm (lowest cutting height position) 45mm 65mm (highest cutting height position) 15 | Page... - Page 16 OPERATING Connect to power supply Warning! Before connecting to the mains supply, always check the switch is in off position. Connect the plug into the RCD protected power supply. a. Starting On/Off switch fig.3) Caution! Do not start the mower if it is standing in long grass. Press the safety button (A) of the switch assembly and then pull the switch lever (B) against the bar.
- Page 17 Turn left and change to position D. Repeat the above processes if needed. c. Instructions for the grass catcher Putting the grass catcher in place: Lift the deflector and place the grass catcher on the tabs. Emptying the grass catcher: Before working on the grass catcher, switch off the engine and wait for the blade to fully stop.
-
Page 18: Maintenance And Storage
MAINTENANCE AND STORAGE 1. Keep all nuts, bolts and screws firmly tightened to ensure that the mower can operate safely. 2. Check the mower deck and grass catcher frequently and make sure they are not worn or damaged. 3. Replace worn or damaged parts for your safety. 4. - Page 19 Replacing the blade: 9. Put the machine on its side. 10. Place the ring on the engine shaft. 11. Place the blade, screw and spring washer. 12. Position the blade on the centring devices. 19 | Page...
- Page 20 Warranty We guarantee this product for 2 full years. The warranty period for this item starts on the day of purchase. You can prove the date of purchase by sending us the original receipt. We insure over the entire warranty period: •...
-
Page 21: Declaration Ce
BUILDER ZI, 32 rue aristide Bergès – 31270 Cugnaux - France Declares that the machinery designated below: ELECTRIC MOWER HTDE1200 Serial number: From XXXXXXX to XXXXXXXXX Complies with the provisions of the Directive "machinery" 2006/42/EC and regulations National transposing it;... - Page 22 22 | Page...
Need help?
Do you have a question about the HTDE1200 and is the answer not in the manual?
Questions and answers