Connections - Panasonic Viera TC-22LR30 Operating Instructions Manual

Connections

Notes on connections
• Turn off the power supply for all components before making any connections.
• If the cables necessary for connecting a component to the system are not included with the component or available as an option, you may need to
fashion a cable to suit the component concerned.
• Read the instruction manual for each system component carefully before connecting it.
Connecting the RF in Terminal
CAUTION
Overtightening "Nut type" RF coaxial cables may damage jacks. Finger tighten only.
Antenna Connection
Connect the cable from Antenna to the VHF/UHF terminal on the
unit.
VHF UHF
Antenna Antenna
Mixer
Cable Connection
Connect the cable supplied by your local cable company to VHF/
UHF terminal on the unit.
Note to CABLE system installer:
This re mind er is pro vid ed to call the CABLE (Cable TV) System
Installer's at ten tion to Article 820-40 of the NEC that pro vides
guide lines for proper grounding and, in par tic u lar, specifies that
the cable ground shall be con nect ed to the ground ing system of
the build ing, as close to the point of cable entry as practical.
Cable Box
In from CABLE
Or
Connecting the Antenna / Cable to the RF IN
Terminal (VCR)
Use this configuration when connecting the LCD TV Antenna and
Cable TV system using VCR.
In from cable
TERMINAL ON THE
BACK OF THE CABLE
BOX
CABLE BOX
Note:
• When the RF coaxial cable is connected to the projection display VHF/
UHF terminal via a cable box or VCR, set the TV channel to CH3 or CH4.
This does not apply when signal is input from VIDEO INPUT.
Cable / Antenna Connection
F-Type Antenna
Connector
Antenna
Terminal on the
Back of the TV
Connect the cable from the Output
terminal on the back of the Cable
Box or antenna/cable system to the
Antenna input terminal on the back
of the VCR.
VCR
Or
↑ TO VCR ↑ TO VCR
Incoming Cable from
Antenna or Cable TV System
Incoming 75Ω Cable from
Home Antenna / Cable
Company
15