Table of Contents
Advertisement
Initial Setup (Ready to Play)
Please make all cable or antenna connections before powering on.
Connecting
For ANT./Cable
Connect the cable from
Antenna/Cable to the VHF/
UHF terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on
your cable box to the VHF/
UHF terminal on the unit
with a RF cable.
WARNING:
Overtightening "Nut type" RF
coaxial cables may damage jacks.
Finger tighten only.
Initial Setup (Ready to Play)
1
Plug the unit power cord into
an AC wall outlet.
Press POWER* on the remote or unit.
2
The unit comes on and auto channel
and clock set starts.
CH AUTO SET PROCEEDING
• If you use a cable box, turn it on and set it
to the Public Broadcasting Service (PBS)
channel in your time zone. If you use a
DSS receiver, it must be turned off.
AUTO CLOCK SET
PROCEEDING
CANCEL : PRESS STOP KEY
10
For assistance, please call : 1-800-211-PANA(7262) or send e-mail : consumerproducts@panasonic.com
PV-27DF62 Rear shown.
UNIT
VHF/UHF
VHF/UHF
3
Settings are made automatically.
When setup is done, this screen
appears.
2 / 6 / 2002 WED 12 : 00PM
SETT I NG : CH 1 0
AUTO CLOCK SET
If AUTO CLOCK SET IS
INCOMPLETE screen appears, set
the clock using MANUAL CLOCK
SET procedure on next page.
AUTO CLOCK SET
I S I NCOMPLETE
PLEASE SET CLOCK BY
PRESS I NG ACT I ON KEY
IN from
ANT./CABLE
Cable TV
Converter Box
IN from
ANT./CABLE
DST : ON
COMPLETED
Advertisement
Table of Contents
