Olympus CAMEDIA C-5050 Zoom Reference Manual page 112

4
Press the shutter button on the remote control device.
• The focus and exposure are locked. The self-timer/remote control lamp
blinks for about 2 seconds before taking the picture.
TIPS
The self-timer/remote control lamp does not blink after pressing
the shutter button on the remote control device.
→ The remote control device may be too far from the camera. Move
closer to the camera and press the shutter button on the remote
control device again.
→ There is signal interference. Change the channel as described in
the remote control device's instruction manual.
How to cancel the remote control mode.
→ The remote control mode is not canceled automatically after
shooting. Perform step 2 on page 110 and set the mode to OFF.
• If the remote control receiver is exposed to strong light, the effective
signal distance may be reduced or shooting may not take place.
Note
• To shoot sequential shots using the remote control device, press
and hold the shutter button on the remote control device. If the
camera does not receive the remote control signal properly,
sequential shooting may stop.
• Read the remote control device's instruction manual for information
on playback by remote control device.
Remote control shooting
111
6