EGO CS1610E Repair Manual Line page 5

Troubleshooting
Problem
Saw chains slides on the
sprocket/big noise/saw
chain take off after
starting the machine
Noise
The chain saw overloads
easily during operation
Brake board cannot be
reset
Brake board has high
thrust
Possible Cause
The sprocket was worn out
Gasket broken
Motor bearing was worn out
Normal overload Protection
Brake board is seriously
deformed
Wear Deformation of Brake
Mechanism
Brake Mechanism broken
Fault Position Test & Solution
Sprocket Replace the sprocket
Gasket Replace gasket
Open the housing, replace the motor
Motor
assembly
Don't apply too much force on the chain saw
to see whether it can properly work on light
-
load condition. Avoid heavy load, such as
cutting hard wood or of big diameter.
Brake board Replace brake board
Replace brake Mechanism
Brake Mechanism
Brake Mechanism Replace brake Mechanism
5