Error Messages - Nikon CoolPix S1200pj Reference Manual

Error Messages

The following table lists the error messages and other warnings displayed in the
monitor, as well as the solutions for dealing with them.
Display
O (blinks)
N
Battery exhausted.
P
Battery temperature
high
P
The camera will turn
off to prevent
overheating.
N
No signal. The
camera will turn off.
P
Close the projector
cover
Q (● blinks red)
P
Please wait for the
camera to finish
recording.
N
Memory card is
write protected.
E82
Description
Clock not set.
Battery exhausted.
Battery temperature is
high.
The camera has become
hot.
There is no signal from
the connected device.
The projector cover is
opened.
Camera cannot focus.
Camera cannot perform
other operations until
recording is complete.
Write-protect switch is
in "lock" position.
Solution
Set date and time.
Charge or replace the battery. 16, 18
Turn off camera, and allow
battery to cool down before
resuming use. After five
seconds, the monitor will turn
off and the power-on lamp
will blink rapidly. After the
lamps blink for three minutes,
the camera will turn off
automatically. Pressing the
power switch also turns off
the camera.
The camera turns off
automatically. Leave the
camera off until it has cooled
and then turn it on again.
Input a signal from the
connected device.
• Close the projector cover
• To resume projection, close
the projector cover, turn
the camera off and back on,
and open the projector
cover.
• Refocus.
• Use focus lock.
Wait until message clears
from display automatically
when recording is complete.
Slide write-protect switch to
"write" position.
A
E 61
23
81
81
81
28, 31
68
–
–