Nikon CoolPix S1200pj Reference Manual page 211

Problem
Monitor is blank.
Monitor is hard to read.
Date and time of recording
are not correct.
No indicators displayed in
monitor.
Print date not available.
Date not appearing on
pictures even when Print
date is enabled.
Screen for setting time
zone and date is displayed
when the camera is turned
on.
Camera settings reset.
Cause/Solution
• Camera is off.
• Battery is exhausted.
• Standby mode for saving power. Press the
power switch, shutter-release button, A
button, c button, or b (e movie-record)
button.
• When flash lamp blinks red, wait until flash
has charged.
• Camera and computer are connected via
USB cable.
• Camera and TV are connected via audio/
video cable.
• The monitor turns off, while the projector is
in operation.
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• If camera clock has not been set, "Date not
set" indicator blinks with shooting and movie
recording. Pictures and movies recorded
before clock is set are dated "00/00/0000
00:00" or "01/01/2011 00:00" respectively. Set
the correct time and date from the Time
zone and date option in the setup menu.
• Check camera clock regularly against more
accurate timepieces and reset as required.
Hide info is selected for Photo info.
Select Show info.
Camera clock has not been set.
The current shooting mode is one that does
not support Print date.
Clock battery is exhausted; all settings were
restored to their default values.
Troubleshooting
A
23
22
23
54
72
72, E 21
80
98, E 64
F 5
24, E 61
25, E 61
98, E 64
24, E 61
99, E 66
24, 25
F7