Preparing Your Shuttle For Powermore 250 - Bosch PowerMore 250 Assembly Information

PREPARING YOUR SHUTTLE FOR THE POWERMORE 250
1.) Check the e-bikes configuration in the Diag-
nostic Tool or the Flow App. Under "PowerMore
Ready:" If it says NO go to step 2. If it says YES
go to step 3.
3.) Remove the existing water bottle bolts to
mount the bracket(s).
5.) Proceed to page three if you are going to mount
the PowerMore with only the Bosch Bracket.
pivotcycles.com info@pivotcycles.com
2.) This needs to be turned on via a configuration
request through the Bosch Diagnostic Tool by a
Bosch Certifed Dealer.
Scan this QR Code to find
your local Pivot Dealer.
4.) The Charging Port Cover should be removed
before riding so it doesn't fall off on the trail.
6.) If you are going to use an offset bracket con-
tinue to page four.
1.877.857.4868
2