Rightest GM700SB Getting Started Manual

Rightest ®
Blood Glucose Meter GM700SB Getting Started Guide
Read the manual before your operation, this Getting Started Guide is only for reference.
GM700SB
Display Window:
Show your test result,
messages and relative
information.
Up Button ( )
For operating the
meter.
Main Button ( )
Press to turn on/off
meter or go into setting
mode.
Front View of Meter
Sample Entry
Test strips
View Window
Test strips vial Control Solution
1
Installating the Batteries
1) Turn the meter over. Press and push battery cover to open.
2) Install the battery. Be sure to put battery in correct direction.
3) Slide the battery cover back until it snaps into place.
Test Strip Port:
Insert test strip here until
you hear a click.
Rightest TM GM700SB
Input:3V
Down Button ( )
For operating the
meter.
Back View of Meter
Depth adjustable cap Release button
Lancet carrier Safe switch Hub Plunger
Lancing Device
Protective cover
Lancet
Rightest TM GM700SB
Rightest TM GM700SB
Input:3V
Input:3V
( For self-testing )
2 Setting Up Your Meter - Set the Date, Time, Volume and Measurement Unit
1) Press and release the Main button "
2) Press and hold the Main button "
(Note: The meter will turn off while you are holding down the button. Continue holding down the Main
button to reach the Setting Mode. You will then be asked to set the year.)
3) Press the Left button "
4) Press the Main button "
5) Repeat step 3 and 4 to change the date, time format, hour, minute, volume and unit. After pressing
the main button to confirm the volume setting, your set-up is complete.
NOTE
- Suggest not to use this meter close to source of strong electromagnetic radiation, to avoid
interference with proper operation.
- Suggest to keep meter free of dust, water or any liquid.
Preparing the Lancing Device
3
1) Hold the adjustable depth cap in one hand while holding the base with the other hand. Pull the
cap in the down direction. When a gap appears between the cap and base, pull the two parts in
opposite directions.
2) Remove the adjustable depth cap.
3) Insert a new disposable lancet firmly into the lancet carrier.
" to turn on the meter.
" for 7 seconds to enter the Setting Mode. The year will flash.
" or Right button " " to change the year.
" to confirm the year and move onto the month setting.
1 2 3