Rightest GT100 Getting Started Manual

GT100 Blood Glucose Monitoring System GETTING STARTED GUIDE
TM
UP BUTTON
DOWN BUTTON
MAIN BUTTON
( )
Front View of Meter
Sample Entry
Test strips
View Window
Protective cover
Test strips vial
Lancet
1 Battery Installation
1) Turn the meter over. Press and push battery cover to open.
2) Install the battery. Be sure to put battery in correct direction.
3) Slide the battery cover back until it snaps into place.
1
TEST STRIP PORT
Insert test strip here
until you hear a click.
DISPLAY WINDOW
Shows test results,
messages and
relative information.
Back View of Meter
Clear Cap
Control Solution
Depth adjustable cap Release button
Lancet carrier Safe switch
Lancing Device
2
(For self-testing and professional use)
Setting Up Your Meter - Setting the Date, Volume and Time
2
1) Press and release main button "
2) Press and hold main button "
(NOTE: Prior to setting mode, the meter will turn off. Main button must remain pressed to access
setting mode.)
3) Press up button or down button to change the year.
BATTERY
COVER 4) Press main button "
Slide cover to
change batteries.
METER LABEL
5) Repeat steps 3 and 4 to change the date, time format, hour, minute volume and unit of
measurement. After pressing the main button to confirm the minute setting, your set-up is
finished.
Hub Plunger
NOTE
- In order to ensure proper operation,
electromagnetic radiation.
- Keep meter free of dust and liquids including water.
3 Preparing the Lancing Device
1) Hold the depth adjustable cap in one hand and hold the hub in the other hand. Bend the cap
towards the down side, until a gap appears between the cap and hub.
2) Pull the cap and hub off in opposite directions, remove the cap.
3) Insert a new disposable lancet firmly into lancet carrier.
3
" to turn on the meter.
" for 7 seconds to activate the setting mode. The year will flash.
" to confirm the year and move to month setting.
do not to use this meter close to sources of strong
1 2 3