Rightest GT333 Getting Started Manual

TM
GT333 Blood Glucose Monitoring System GETTING STARTED GUIDE
Test Strip Port
Display Window
Left Button ( )
Front View of Meter
Sample Entry
Test strips
View Window
Control Solution
Protective cover
Test Strips
Test strips vial
Lancet
2

Installing the Batteries

1) Turn the meter over. Press and slide battery cover to open.
2) Install the 2 AAA batteries. Be sure to insert the batteries in the correct direction.
3) Slide the battery cover back on until it snaps into place.
1 2
3

Setting Up Your Meter - Setting the Date, Time , Volume and Measurement Unit

1) Press and release the Main button " " to turn on the meter.
2) Press and hold the Main button " " for 7 seconds to enter the Setting Mode. The year will flash.
(Note: The meter will turn off while you are holding down the button. Continue holding down the Main
button to reach the Setting Mode. You will then be asked to set the year.)
Battery Cover
Main Button ( )
Right Button ( )
Back View of Meter
Clear Cap
30 ℃
2 ℃
Depth adjustable cap
Release button
Lancet carrier Safe switch
Lancing Device
3
(For self-testing and professional use)
3) Press the Left button "
4) Press the Main button "
5) Repeat step 3 and 4 to change the date, time format, hour, minute, volume and unit. After
pressing the main button to confirm the volume setting, your set-up is complete.
Meter label
NOTE
- Suggest not to use this meter close to source of strong electromagnetic radiation, to avoid interference with
proper operation.
4

Preparing the Lancing Device

1) Hold the depth adjustable cap in one hand and hold the hub in the other hand. Bend the cap towards the down
Hub Plunger
side, until a gap appears between the cap and hub.
2) Pull the cap and hub off in opposite directions, remove the cap.
3) Insert a new disposable lancet firmly into the lancet carrier.
1
4) Twist off and set aside the protective cover of the disposable lancet.
5) Replace the depth adjustable cap.
6) Choose a depth of penetration by rotating the top portion of the depth adjustable cap until the setting depth
matches the window. Settings are based on skin type
"
"
"
7) Hold the hub in one hand and pull on the plunger in the other hand. The device will be cocked. Release the
plunger, it will automatically move back to its original position near the hub.
4
" or Right button " " to change the year.
" to confirm the year and move onto the month setting.
2 3
" for soft or thin skin;
" for average skin;
" for thick or calloused skin.
5 6 7