MSI 915 User Manual page 65

IO Devices Configuration
Press <Enter> and the following sub-menu appears:
POWER ON Function
This controls how the PS/2 mouse or keyboard can power on the system. Settings:
[Password], [Hot KEY], [Mouse Left], [Mouse Left], [Mouse Right], [any KEY],
[BUTTON ONLY], [Keyboard 98].
KB Power ON Password
If POW ER ON Function is set to Password, then you can set a password in the
field for the PS/2 keyboard to power on the system.
Hot Key Power ON
If POWER ON Function is set to [Hot KEY], you can assign a hot key combina-
tion in the field for the PS/2 keyboard to power on the system. Settings: [Ctrl-F1]
through [Ctrl-F12].
Onboard FDC Controller
Select [Enabled] if your system has a floppy disk controller (FDD) installed on the
system board and you wish to use it. If you install add-on FDC or the system has no
floppy drive, select [Disabled] in this field. Setting options: [Enabled], [Disabled].
COM Port 1/2
This item specifies the base I/O port addresses of the onboard Serial Port 1/2 (COM
1/2). Selecting [Auto] allows BIOS to automatically determine the correct base I/O
port address. Settings: [3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ4], [2E8/IRQ3] and [Disabled].
UART Mode Select
This setting allows you to specify the operation mode for serial port 2. Setting
options: IrDA, ASKIR, Normal.
NormalRS-232C Serial Port
IrDA
ASKIR
IrDA-compliant Serial Infrared Port
Amplitude Shift Keyed Infrared Port
4-15
Bios Setup