Lan Led Connectors: Jact1, Jact2; Front Panel Connector: Jfp1 - MSI 5000V Master2 Series User Manual

LAN LED Connectors: JACT1, JACT2

The LAN LED connectors are used to connect to LAN LEDs, which show the activity
of the LAN. The JACT1 is for the LAN 1 jack and the JACT2 is for the LAN2 jack. Both
LAN1 & LAN2 jacks are located on the back panel.

Front Panel Connector: JFP1

The mainboard provides one front panel connector for electrical connection to the
front panel switches and LEDs. The JFP1 is compliant with Intel
Connectivity Design Guide.
PIN
1
2
3
4
5
6
7
8
9
+ +
JACT2
- -
Reset
Switch
-
+
9
JFP1
10
-
+
Power
Switch
JFP1 Pin Definition
SIGNAL DESCRIPTION
HD_LED + Hard disk LED pull-up
FP PWR/SLP MSG LED pull-up
HD_LED - Hard disk active LED
FP PWR/SLP MSG LED pull-up
RST_SW - Reset Switch low reference pull-down to GND
PWR_SW + Power Switch high reference pull-up
RST_SW + Reset Switch high reference pull-up
PWR_SW - Power Switch low reference pull-down to GND
RSVD_DNU Reserved. Do not use.
Hardware Setup
JACT1
HDD
LED
-
+
1
2
Power
LED
®
Front Panel I/O
2-13