Figure 6. Installing a 3.5-inch hard disk drive into the bracket
Figure 7. Installing a 2.5-inch hard disk drive into the bracket
7. Install the hard disk drive and bracket into the drive bay.
8. Using the signal cable that came with the new drive, connect one end of the
156
Hardware Maintenance Manual
Note: If you are installing a 2.5-inch hard disk drive into the bracket, flex the
bracket, and then align pin 1 , pin 2 , pin 3 , and pin 4 on the
bracket with the holes in the hard disk drive adapter 5 .
signal cable to the drive. Locate one of the extra five-wire power cables and
connect it to the drive.
Note: The signal cable will be different depending on whether you are
installing a SATA hard disk drive or a SAS hard disk drive.