Replacing The Heat Sink - Lenovo ThinkStation S20 4157 Hardware Manual

10. Latch the adapter card retainer.
11. Go to "Completing the FRU replacement" on page 131.

Replacing the heat sink

CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and
wait three to five minutes to let the computer cool before opening the computer
cover.
This section provides instructions on how to replace and install the heat sink.
To replace the heat sink:
9. Connect any adapter card cables to the system board.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkStation Safety and Warranty Guide that came
with your computer. To obtain a copy of the ThinkStation Safety and Warranty Guide, go to:
http://www.lenovo.com/support
1. Open the computer cover. See "Removing the cover" on page 96.
2. Lay the computer on its side for easier access to the heat sink.
3. Remove the heat sink and fan assembly cable from the system board. Note the
cable location. See "Locating parts on the system board" on page 98.
4. Follow this sequence to remove the heat sink from the system board:
a. Partially remove screw 1 , then fully remove screw 2 , and fully remove
screw 1 .
b. Partially remove screw 3 , then fully remove screw 4 , and fully remove
screw 3 .
Chapter 10. Replacing FRUs - Menorca Computers
109